Select Enable Network
Flashing.
The TCP/IP protocol
is now initialized. This process will take no
more than 60
seconds to scan for a DHCP assigned IP address.
Obviously make a note
of whatever address you are assigned and then
skip the next step.
If a DHCP assigned
IP address cannot be found then you are assigned
a static
IP address (always 192.168.0.99)
Open up Internet
Explorer (may or may not work in Firefox) and
type in the IP
address that you have been assigned e.g.
http://192.168.0.99. If your network
is working correctly you will see this screen.
All you need to do is make sure you
have the bios you wish to upload and that your
X3 switches are set to 1mb mode
(this can also be achieved by not connected the
switch at all - default is 1MB Banks 1234)
Everything is explained on screen. For this example
we have selected X3 1959 Bios.
Now select upload
and flash.
Now you need to
check your TV screen to see if everything is going
smoothly.
This is what happens
if your X3 has its flash protection enabled. You
wont
be able to update anything at this stage. You
need to make sure the flash
protection is set to off on the mod and on the
switch if you have it connected.
You will need to start over from the beginning.
As you can see the
1MB (1024k) Bios has been grabbed from the network,
the X3 2MB (2048k) Flash Rom has been detected
and things are progressing
nicely. The yellow bar = ERASING.
Superb we are almost
there. The green bar = FLASHING.
The Flash has now
completed. The Xbox will now turn off automatically.
Now turn it back on again yourself (quick press
power button so X3 Logo
on switch is BLUE).
Success! Enjoy Your
new Xbox adventure.
|
