Tools required:

- Soldering iron - A basic soldering iron will do with an output of around 15W, too hot an iron could cause problems for beginers.
- Solder
- Flux paste and pen - these are recomended to ensure a clean strong connection
- Electrical tape
- Torx screwdrivers - Torx 10 and Torx 20

Version 1.0

The V1.0 motherboard has the LPC points filled with solder, it is recomended to use the supplied wired pinheader.
It is possible to remove the solder from the LPC ports if you have the correct equipment.

Version 1.6

The V1.6 motherboards will require a LPC rebuild and a pin to be removed from the pin header before soldering into the LPC. A 5v wire is also provided for this version mother board.