|
As an additional reference, we have added links to the video
tutorials.
1.As indicated by the picture, remove the 4 bottom left rubber
stand and screws by using the screw driver provided. (keep
the screws, don't lose them)
2.As indicated by the picture, remove the bottom rubber stand
and screws by using the classic screw driver provided.
3.remove the battery and the screw.
4.Follow the instruction to
take off these 2 plastic plates.
5.As indicated by the picture, remove those 3 screws
by using the classic screw driver provided.
6.Remove the top plate of the console then those 4 screws.
7.As indicated by the picture, unplug the power source.
8.Remove the right plastic plate and the metal DVD rom cover,
and take off the screws as indicated in the picture.
9.Open the DVD rom ,and follow the instruction of the number
to take off the cables.
10.Remove those screws.
11.As shown in the picture, unplug the power source of the
fan.
12.Remove the fan and the flow wind tunnel then take off
3 screws.
13.Remove the black plastic part then take off those 14 screws.
14.Take off the tape then remove the metal part.
15.Take off 4 screws and remove the heat sink.
16.Remove all the parts from the left plastic plate.
17.Place the rubber stand from the left plate to the same
position of the replacement i case.
18.put back the metal plate to the replacement i case.
19.replace the mother board, put the indicated small metal
plate to that position, then put down the heat sink and put
on 4 screws.
20.Put on the metal cover and those 15 screws.
21.Put on the black plastic bar and 3 screws.
22.Place the fan and the flow wind tunnel, plug on the power
source as indicated on the picture then put on 9 screws.
23.Plug the cables .
24.Put on 4 screws.
25.As shown on the picture, place the protective dust cover
to the i case.
26.Place the the right plate to the console, put on 4 screws.
27.As shown in the pictures, put on the LED part.
28.Put on those parts to the i case face plate .
29.Put on 3 screws.
30.Plug on the power source.
31.Put on the front plastic plates and 3 screws, then install
2 protective dust covers.
32. Put on 5 screws.
33. As indicated in the picture, put on the screw and the
battery, place it back to the console then put on the rubber
stands.
34.Put on 4 screws, rubber stands and tape.
35.Insatallation finished.
|
