|
Thank
you to XCM Team for this TUTORIAL!
Get your XBOX 360 Case Mods HERE
Get your
XBOX 360 UNLOCK KIT HERE
IF
YOU ARE LOOKING FOR THE XCM CASE INSTALLATION GUIDE GO HERE
IF
YOU ARE LOOKING FOR THE XCM X-WINDOW W/ LEDS GUIDE GO HERE
IF
YOU ARE LOOKING FOR THE XCM CUSTOM 360 CASE W/ LEDS GUIDE
GO HERE
1.Follow the instruction
to take off the xbox 360 face plate..
2.Remove the bottom left rubber stand.
3.Follow the instruction to insert the XCM
opening tool to the square hole (make it close to the edge
of the hole then turn right as picture A, turn left as it
shows on picture C)
As shown by the diagram B, the XCM opening
tool is used for removing the inside piece of plastic
lock.
¡@
4.Plug in the XCM opening tool to the base
grille to take off the right heat panel.
5.Plug in the XCM opening tool to the base
grille to take off the left heat panel.
6.Take the heat panels apart.
7.Remove seal.
8.Unplug the 4 buckles
9.Plug in our XCM opening tool to the indicated
holes, press it hard to let the top and bottom panels
apart.
10.Take away the two parts.
11.Remove the DVD drive Eject button.
12.As indicated by the arrow, remove the 6 screws by using
the Allen key provided.
13.Remove the tray face plate.
14.All case components are displayed.
|
