We carry many XCM Wireless controller case mods here and XCM Wired controller case mods here
How to disassemble the wired Xbox 360 controller
CLICK ALL IMAGES FOR LARGER VERSION!

1.As shown in the diagram,using the XCM screw driver to take off the 7 screws as indicated.

2.As shown in the diagram, take off the internal parts.

3.As shown in the diagram, take off these 2 screws.

4.Insert the screw driver into the holes then press. As indicated in the diagram, use the screw driver to apply pressure to the area indicated.

5.remove the rubbers and the buttons as shown in the picture.

6.As shown in the diagram,remove the RT ,LT buttons.

7.disassembly is completed.
How to install the wired XCM 360 controller shell

8.XCM RT and LT buttons.

9.As shown in the diagram, install the RT and LT buttons step by step.

10.Screw the direction button back to the shell, place the rubber on.

11.As shown in the diagram, solder these 3 wires. This is for the LED Lights!
12.Close the controller bottom,put on those screws.

13.Installation complete.

14.Switch to ● for turning on the controller LED light, Switch to ○ for turning off the controller LED light.
|