We carry many XCM Wireless controller case mods here and XCM Wired controller case mods here
How to disassemble the XBOX 360 wireless controller.
CLICK ALL THE IMAGES FOR LARGER VERSIONS!
1.As shown in the diagram, take off the battery pack and using the XCM screw driver to take off the 7 screws as indicated
2.As shown in the diagram, take off the internal parts.
3.As shown in the diagram, take off these 2 screws.
4.Insert the screw driver into the holes then press. As indicated in the diagram, use the screw driver to apply pressure to the area indicated.
5.remove the rubbers and the buttons as shown in the picture.
6.As shown in the diagram,remove the RT ,LT buttons
7.disassemble is completed.
8. XCM RT and LT buttons.
9.As shown in the diagram, install the RT and LT buttons step by step.
10.Screw the direction button back to the shell, place the rubber on.
11.As shown in the diagram, solder these 3 wires. This is required for the LED Lights.
12. Fit the PCB as snugly to the case as possible.As shown in the diagram,push the back of on-live button close to this point,make sure the button working properly before closing the controller case.
13.Close the controller bottom,put on the 7 screws then cover the battery pack back to the place.
14.Installation complete.
|
